Front mounts

I got the passenger side mount in. This is the mount that Stovebolt engineering aka Tom Langdon sells. The drivers side mount needs a little less than a quarter inch taken off the height to fit inside the frame rails. Should be a simple cut and re-weld. I thought I might take it down to the exhaust shop down the street and let then throw a bead down on it. They said they would only charge me $20. But I think my little 110 welder might be up to the task. I thought I was going to need to drop the leaf springs down in order to drill the bottom mounting holes. But my drill bit was just long enough to go thru the top hole to drill the bottom hole. I'm using 7/16 grade eight hardware. Now that its all mocked up I will pull the mount and paint it and red loctight the bolts.